Pub Stuff Party 9 Drinks Dispenser Instructions

PUB STUFF DRINKS DISPENSER INSTRUCTIONS USES The Pub Stuff Party 9 Drinks Dispenser may be used to serve all types of drink (beer, wine, soft drinks, juices, beverages, cocktails etc.) hot and cold, fizzy or still – The Pub Stuff Party 9 Drinks Dispenser is not recommended for serving drinks which contain solid materials (for example fruit pulp) which could jam the valves. FOOD SAFETY All the plastic materials used in the manufacture of the portable Pub Stuff Party 9 Drinks Dispenser are suitable in accordance with European Legislation for plastics in contact with food (Directive 2002/72/CEE) and subsequent modifications, and the legislation of the USA Food and Drugs Administration (CFR 21.177.1580). ASSEMBLY, FILLING AND USE 1. Before assembly, place the plastic cooling block in the freezer. 2. Mount the tripod on the tray. First position two of the legs and then gently push the third leg so that it slides into place. 3. Place the previously frozen cooling block into the tripod. 4. Fill the vessel of the Pub Stuff Party 9 Drinks Dispenser with your chosen drink. Maximum capacity 5L/9pt. 5. Place the vessel of the Pub Stuff Party 9 Drinks Dispenser on the Tripod until it locks into position. 6. Cover the lid. 7. Serve drink with one, two or three taps, pouring individually or simultaneously. CARRYING The Pub Stuff Party 9 Drinks Dispenser can be carried, even when full with drink and with glasses on the tray. You MUST do this by holding the tripod with one hand and supporting the tray with the other. Never carry the Pub Stuff Party 9 Drinks Dispenser full assembled, with glasses and drink, without supporting the tray with at least one hand. DISMANTLING The vessel of the Pub Stuff Party 9 Drinks Dispenser may be taken off the tripod by simultaneously sliding two of the levers under the tripod with two thumbs. Slide the levers fully, whilst still maintaining pressure on one of the levers with one thumb. Lift the vessel off the tripod with your other hand. The tripod comes off the tray by pressing the legs sideways to free them from their blocking position. CLEANING • Clean and rinse the vessel with plenty of water after each use. • Place the vessel on the tripod and pour clean water through each of the three taps. • Wash the vessel with warm water, (no hotter than 60 degrees C /140 degrees F) and mild detergents. • Do not use cleaning agents which contain amines, ammonia, solvents or high gloss drying agents. • Hand wash only. Do not use in Dishwasher. It is not recommended as it could deteriorate the decorative vinyl stickers and cause loss of transparency of the vessel. MAINTENANCE All components of the Pub Stuff Party 9 Drinks Dispenser may be taken apart for optimum hygiene. In the event of partial wear and breakage of the Pub Stuff Party 9 Drinks Dispenser, the main components may be purchased as spares.